Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
353
config wac
config radius commands located in the 802.1x section.
default_redirpath - Enter the URL of the website that authenticated
users placed in the VLAN are directed to once authenticated. This path
must be entered into this field before the Web-based Access Control
can be enabled.
Restrictions The WAC VLAN, ports and method can only be configured separately.
Only administrator-level users can issue this command.
Example usage:
To configure the WAC VLAN:
DGS-3600:4#config wac vlan Trinity
Command: config wac vlan Trinity
Success.
DGS-3600:4#
Example usage:
To configure the WAC ports:
DGS-3600:4#config wac ports 1-7 state enable
Command: config wac ports 1-7 state enable
Success.
DGS-3600:4#
Example usage:
To configure the Web-based Access Control method:
DGS-3628:4#config wac method local
Command: config wac method local
Success.
DGS-3600:4#
NOTE: To enable the Web-based Access Control function, the redirection
path field must have the URL of the website that users will be directed to
once they enter the limited resource, pre-configured VLAN. Users which
attempt Apply settings without the Redirection Page field set will be
prompted with an error message and Web-based Access Control will not
be enabled. The URL should follow the form http(s)://www.dlink.com
NOTE: The subnet of the IP address of the authentication VLAN must be
the same as that of the client, or the client will always be denied
authentication.