Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
373
config authen server_group
protocol may be added to this group.
! xtacacs – Use this parameter to utilize the built-in XTACACS server
protocol on the Switch. Only server hosts utilizing the XTACACS
protocol may be added to this group.
! tacacs+ – Use this parameter to utilize the built-in TACACS+ server
protocol on the Switch. Only server hosts utilizing the TACACS+
protocol may be added to this group.
! radius – Use this parameter to utilize the built-in RADIUS server
protocol on the Switch. Only server hosts utilizing the RADIUS
protocol may be added to this group.
! <string 15> - Enter an alphanumeric string of up to 15 characters to
define the previously created server group. This group may add any
combination of server hosts to it, regardless of protocol.
add/delete – Enter the correct parameter to add or delete a server host from a
server group.
server_host <ipaddr> - Enter the IP address of the previously configured server
host to add or delete.
protocol – Enter the protocol utilized by the server host. There are three
options:
! tacacs – Use this parameter to define the protocol if the server host is
using the TACACS authentication protocol.
! xtacacs – Use this parameter to define the protocol if the server host
is using the XTACACS authentication protocol.
! tacacs+ – Use this parameter to define the protocol if the server host
is using the TACACS+ authentication protocol.
! radius – Use this parameter to define the protocol if the server host is
using the RADIUS authentication protocol.
Restrictions Only administrator-level users can issue this command.
Example usage:
To add an authentication host to server group “group_1”:
DGS-3600:4# config authen server_group group_1 add server_host
10.1.1.121 protocol tacacs+
Command: config authen server_group group_1 add server_host
10.1.1.121 protocol tacacs+
Success.
DGS-3600:4#
delete authen server_group
Purpose Used to delete a user-defined authentication server group.
Syntax
delete authen server_group <string 15>
Description This command will delete an authentication server group.
Parameters <string 15> - Enter an alphanumeric string of up to 15 characters to
define the previously created server group to be deleted.
Restrictions Only administrator-level users can issue this command.
Example usage:
To delete the server group “group_1”: