Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
211
1:13 ForceAuth Success Authorized
1:14 ForceAuth Success Authorized
1:15 ForceAuth Success Authorized
1:16 ForceAuth Success Authorized
1:17 ForceAuth Success Authorized
1:18 ForceAuth Success Authorized
1:19 ForceAuth Success Authorized
1:20 ForceAuth Success Authorized
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
Example usage:
To display the 802.1x auth state for MAC-based 802.1x:
DGS-3600:4#show 802.1x auth_state
Command: show 802.1x auth_state
Port number : 1
Index MAC Address Auth PAE State Backend State Port Status
------ ------------------- ----------------------- --------------------- -----------------
1:1 00-08-02-4E-DA-FA Authenticated Idle Authorized
1:2
3
1:4
1:5
1:6
1:7
1:8
1:9
1:10
1:11
1:12
1:13
1:14
1:15
1:16
CTRL+C ESC q Quit SPACE n Next Page Enter Next Entry a All
config 802.1x auth_mode
Purpose Used to configure the 802.1x authentication mode on the Switch.
Syntax
config 802.1x auth_mode {port_based | mac_based]
Description The config 802.1x auth_mode command is used to enable either
the port-based or MAC-based 802.1x authentication feature on the
Switch.
Parameters
[port_based | mac_based] − The Switch allows users to authenticate
802.1x by either port or MAC address.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure 802.1x authentication by MAC address:
DGS-3600:4#config 802.1x auth_mode mac_based
Command: config 802.1x auth_mode mac_based
Success.
DGS-3600:4#