Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
202
To configure the limited multicast address on ports 1-3:
DGS-3600:4#config limited multicast address 1-3 from 224.1.1.1 to 224.1.1.2 access
permit state enable
Command: config limited multicast address 1-3 from 224.1.1.1 to 224.1.1.2 access
permit state enable
Success.
DGS-3600:4#
delete limited multicast address
Purpose Used to delete Limited IP multicast address range.
Syntax
delete limited multicast address [all | <portlist>]
Description The delete limited multicast address command allows the user to
delete all multicast address ranges or a selected range based on
what port or ports the range has been assigned to.
Parameters all - Allows the user to delete all limited multicast addresses that
have been configured on the Switch.
<portlist> - Allows the user to delete only those multicast address
ranges that have been assigned to a particular port or range of ports.
The port list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon. Then
the highest switch number, and the highest port number of the range
(also separated by a colon) are specified. The beginning and end of
the port list range are separated by a dash. For example, 1:3
specifies switch number 1, port 3. 2:4 specifies switch number 2,
port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and
switch 2, port 4 − in numerical order. Non-contiguous portlist entries
are separated by a comma. (ex: 1:1-1:3,1:7-1:9)
Restrictions Only administrator-level users can issue this command. This
command is used as a backwards compatible command for legacy
devices.
Example usage:
To delete the limited multicast address on ports 1-3:
DGS-3600:4#delete limited multicast address 1-3
Command: delete limited multicast address 1-3
Success.
DGS-3600:4#
show limited multicast address
Purpose Used to show per-port limited IP multicast address range.
Syntax
show limited multicast address {<portlist>}
Description The show limited multicast address command allows users to
show multicast address range by ports.
Parameters <portlist> A port or range of ports on which the limited multicast
address range to be shown has been assigned. The port list is