xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
56
upload
• <path_filename 64> − The DOS path and filename of the log file to be
uploaded on the TFTP server. For example, C:\3600.txt.
firmware_toTFTP – Use this parameter to upload firmware to a TFTP server.
• <ipaddr> − The IP address of the TFTP server.
• <ipv6addr> - The IPv6 address of the TFTP server.
• <path_filename 64> − The DOS path and filename of the log file to be
uploaded on the TFTP server. For example, C:\3600.txt.
• <drive_id> - Enter the drive ID of the internal flash drive to where to
upload the file.
• {<path_filename 64>} – The second path_filename in the command
refers to the flash memory located on the Switch. This drive is
nominated c: and those who wish to save this file to a TFTP server
must enter the path and file name of the configuration file located on
the flash memory of the Switch using this parameter.
attack_log_toTFTP - This command is used to upload a switch attack log to a
TFTP server, such as a spoofing attack.
• <ipaddr> - Enter the IPv4 address of the TFTP server to which to
upload the attack log.
• <ipv6addr> - Enter the IPv6 address of the TFTP server to which to
upload the attack log.
• <path_filename 64> - Specifies the location of the Switch configuration
file on the TFTP server. This file will be replaced by the uploaded file
from the Switch.
• unit <unit_id 1-12> - Select the switch in the switch stack from where
these attack log files will be uploaded, denoted by unit ID number.
• all – Use this parameter to select all switches in the switch stack.
Restrictions Only administrator-level users can issue this command.
Example usage:
To upload a configuration file to the TFTP server.
DGS-3600:4# upload cfg_toTFTP 10.53.13.3 c:\3600.cfg
Command: upload cfg_toTFTP 10.53.13.3 c:\3600.cfg
Connecting to server…………………………..Done.
Upload configuration…………………………..Done.
DGS-3600:4#
To upload a configuration file saved in the flash memory of the Switch to the TFTP server.