Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
361
config authen_login
tacacs host in the server group. If no response comes from the server
host, the Switch will send an authentication request to the second tacacs
host in the server group and so on, until the list is exhausted. At that
point, the Switch will restart the same sequence with the following
protocol listed, xtacacs. If no authentication takes place using the xtacacs
list, the local account database set in the Switch is used to authenticate
the user. When the local method is used, the privilege level will be
dependant on the local account privilege configured on the Switch.
Successful login using any of these methods will give the user a “user”
privilege only. If the user wishes to upgrade his or her status to the
administrator level, the user must implement the enable admin command,
followed by a previously configured password. (See the enable admin
part of this section for more detailed information, concerning the enable
admin command.)
Parameters default – The default method list for access authentication, as defined by
the user. The user may choose one or a combination of up to four of the
following authentication methods:
! tacacs – Adding this parameter will require the user to be
authenticated using the TACACS protocol from the remote
TACACS server hosts of the TACACS server group list.
! xtacacs – Adding this parameter will require the user to be
authenticated using the XTACACS protocol from the remote
XTACACS server hosts of the XTACACS server group list.
! tacacs+ – Adding this parameter will require the user to be
authenticated using the TACACS+ protocol from the remote
TACACS+ server hosts of the TACACS+ server group list.
! radius - Adding this parameter will require the user to be
authenticated using the RADIUS protocol from the remote
RADIUS server hosts of the RADIUS server group list.
! server_group <string 15> - Adding this parameter will require
the user to be authenticated using a user-defined server group
previously configured on the Switch.
! local - Adding this parameter will require the user to be
authenticated using the local user account database on the
Switch.
! none – Adding this parameter will require no authentication to
access the Switch.
method_list_name – Enter a previously implemented method list name
defined by the user. The user may add one, or a combination of up to
four of the following authentication methods to this method list:
! tacacs – Adding this parameter will require the user to be
authenticated using the TACACS protocol from a remote
TACACS server.
! xtacacs – Adding this parameter will require the user to be
authenticated using the XTACACS protocol from a remote
XTACACS server.
! tacacs+ – Adding this parameter will require the user to be
authenticated using the TACACS+ protocol from a remote
TACACS+ server.
! radius - Adding this parameter will require the user to be
authenticated using the RADIUS protocol from a remote
RADIUS server.
! server_group <string 15> - Adding this parameter will require
the user to be authenticated using a user-defined server group
previously configured on the Switch.
! local - Adding this parameter will require the user to be
authenticated using the local user account database on the