Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
136
delete link_aggregation group_id
Purpose Used to delete a previously created link aggregation group.
Syntax
delete link_aggregation group_id <value 1-32>
Description This command is used to delete a previously configured link aggregation
group.
Parameters
<value 1-32> − Specifies the group ID. The Switch allows up to 32 link
aggregation groups to be configured. The group number identifies each of the
groups.
Restrictions Only administrator-level users can issue this command.
Example usage:
To delete link aggregation group:
DGS-3600:4#delete link_aggregation group_id 6
Command: delete link_aggregation group_id 6
Success.
DGS-3600:4#
config link_aggregation
Purpose Used to configure a previously created link aggregation group.
Syntax
config link_aggregation group_id <value 1-32> {master_port <port> |
ports <portlist> | state [enable | disable]
Description This command allows users to configure a link aggregation group that was
created with the create link_aggregation command above. The DGS-3600
supports link aggregation cross box which specifies that link aggregation
groups may be spread over multiple switches in the switching stack.
Parameters
group _id <value 32> − Specifies the group ID. The Switch allows up to 32
link aggregation groups to be configured. The group number identifies each of
the groups.
master_port <port> − Master port ID. Specifies which port (by port number) of
the link aggregation group will be the master port. All of the ports in a link
aggregation group will share the port configuration with the master port.
ports <portlist> − Specifies a port or range of ports that will belong to the link
aggregation group including the master port. The port list is specified by
listing the lowest switch number and the beginning port number on that
switch, separated by a colon. Then the highest switch number, and the
highest port number of the range (also separated by a colon) are specified.
The beginning and end of the port list range are separated by a dash. For
example, 1:3 specifies switch number 1, port 3. 2:4 specifies switch number
2, port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and switch
2, port 4 − in numerical order. Non-contiguous portlist entries are separated
by a comma. (ex: 1:1-1:3,1:7-1:9)
state [enable | disable] − Allows users to enable or disable the specified link
aggregation group.
Restrictions Only administrator-level users can issue this command. Link aggregation
groups may not overlap.
Example usage:
To define a load-sharing group of ports, group-id 1,master port 5 with group members ports 5-7 plus port 9: