D-Link DGS-3600 Switch User Manual


 
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
146
Example usage:
To enable IP-MAC Binding ACL mode on the Switch:
DGS-3600:4#enable address_binding acl_mode
Command: enable address_binding acl_mode
Success.
DGS-3600:4#
disable address_binding acl_mode
Purpose Used to disable the ACL mode for an IP-MAC binding entry.
Syntax
disable address_binding acl_mode
Description This command, along with the enable address_binding acl_mode
will enable and disable the ACL mode for IP-MAC binding on the
Switch, without altering previously set configurations. When
disabled, the Switch will automatically delete two previously created
ACL packet content mask entries that can be viewed using the show
access_profile command.
Parameters None.
Restrictions Only administrator-level users can issue this command. The ACL
entries created when this command is enabled, can only be
automatically installed if the Access Profile table has two entries
available of the possible 9 entries allowed. These access profile
entries can only be deleted using the disable address_binding
acl_mode and NOT though the delete access_profile profile_id
command. Also, the show config command will not display the
commands for creating the IP-MAC ACL mode access profile
entries.
Example usage:
To disable IP-MAC Binding ACL mode on the Switch:
DGS-3600:4#disable address_binding acl_mode
Command: disable address_binding acl_mode
Success.
DGS-3600:4#
enable address_binding trap_log
Purpose Used to enable the trap log for the IP-MAC binding function.
Syntax
enable address_binding trap_log
Description This command, along with the disable address_binding trap_log
will enable and disable the sending of trap log messages for IP-MAC
binding. When enabled, the Switch will send a trap log message to
the SNMP agent and the Switch log when an ARP packet is received
that doesn’t match the IP-MAC binding configuration set on the
Switch.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage: