Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
57
DGS-3600:4# upload cfg_toTFTP 10.53.13.3 c:\3600.cfg c:\startup.cfg
Command: upload cfg_toTFTP 10.53.13.3 c:\3600.cfg c:\startup.cfg
Connecting to server…………………………..Done.
Upload configuration…………………………..Done.
DGS-3600:4#
config firmware image
Purpose Used to configure a firmware file located in the flash memory as the
boot up section.
Syntax
config firmware image {{unit [<unitid 1-12> | all]} <drive_id>}
<pathname 64> boot_up
Description This command is used to configure firmware files located on the flash
memory of the Switch, as the boot up configuration file.
Parameters unit <unit_id 1-12> - Select the switch in the switch stack where the
firmware image is that will be configured, denoted by unit ID number.
all – Use this parameter to select all switches in the switch stack.
<drive_id> - Enter the drive ID of the internal Flash drive to where to
upload the file.
<pathname 64> - Enter the path and file name of the firmware file
located in the Switch’s flash memory, which will be used as the boot
up firmware upon next reboot of the Switch.
boot_up – Entering this parameter will specify the firmware file as a
boot up section.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure firmware section 1 as a boot up section:
DGS-3600:4# config firmware image c:/3600.had boot_up
Command: config firmware image c:/3600.had boot_up
Success.
DGS-3600:4#
show config
Purpose
Used to display the current or saved version of the configuration settings of the
switch.
Syntax
show config [active | boot_up | {<drive_id>} <pathname 64>]
Description
Use this command to display all the configuration settings that are saved to NV
RAM or display the configuration settings as they are currently configured. Use the
keyboard to list settings one line at a time (Enter), one page at a time (Space) or
view all (a).
The configuration settings are listed by category in the following order: