Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
123
config vlan delete
list is specified by listing the lowest switch number and the beginning
port number on that switch, separated by a colon. Then the highest
switch number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of the port
list range are separated by a dash. For example, 1:3 specifies switch
number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4
specifies all of the ports between switch 1, port 3 and switch 2, port 4
− in numerical order. Non-contiguous portlist entries are separated by
a comma. (ex: 1:1-1:3,1:7-1:9)
Restrictions Only administrator-level users can issue this command.
Example usage:
To delete ports 5-7 of module 1 of the VLAN v1:
DGS-3600:4#config vlan v1 delete 1:5-1:7
Command: config vlan v1 delete 1:5-1:7
Success.
DGS-3600:4#
config gvrp
Purpose Used to configure GVRP on the Switch.
Syntax
config gvrp [<portlist> | all] {state [enable | disable] | ingress_checking
[enable | disable] | acceptable_frame [tagged_only | admit_all] | pvid
<vlanid 1-4094>}
Description This command is used to configure the GARP VLAN Registration Protocol on
the Switch. Configurable settings include ingress checking, the sending and
receiving of GVRP information, and the Port VLAN ID (PVID).
Parameters
<portlist> − A port or range of ports for which to configure GVRP. all − Specifies
all of the ports on the Switch. The port list is specified by listing the lowest switch
number and the beginning port number on that switch, separated by a colon.
Then the highest switch number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of the port list range
are separated by a dash. For example, 1:3 specifies switch number 1, port 3.
2:4 specifies switch number 2, port 4. 1:3-2:4 specifies all of the ports between
switch 1, port 3 and switch 2, port 4 − in numerical order. Non-contiguous portlist
entries are separated by a comma. (ex: 1:1-1:3,1:7-1:9)
state [enable | disable] − Enables or disables GVRP for the ports specified in the
port list.
ingress_checking [enable | disable] − Enables or disables ingress checking for
the specified port list.
acceptable_frame [tagged_only | admit_all] – This parameter states the frame
type that will be accepted by the Switch for this function. Tagged_only implies
that only VLAN tagged frames will be accepted, while admit_all implies tagged
and untagged frames will be accepted by the Switch.
pvid – Specifies the default VLAN ID associated with the port.
Restrictions Only administrator-level users can issue this command.
Example usage:
To set the ingress checking status, the sending and receiving GVRP information :
DGS-3600:4#config gvrp 1:1-1:4 state enable ingress_checking enable
acceptable_frame tagged_only pvid 2
Command: confi
g
g
vr
p
1:1-1:4 state enable in
g
ress
_
checkin
g
enable