Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
178
config mld_snooping mrouter_ports
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure MLD snooping multicast router ports:
DGS-3600:4#config mld_snooping mrouter_ports default add 1:1-1:10
Command : config mld_snooping mrouter_ports default add 1:1-1:10
Success.
DGS-3600:4#
config mld_snooping mrouter_ports_forbidden
Purpose Used to configure ports on the Switch as forbidden router ports.
Syntax
config mld_snooping mrouter_ports_forbidden <vlan_name 32> [add |
delete] <portlist>
Description This command allows the user to designate a port or range of ports as being
forbidden from being connected to multicast enabled routers. This ensures that
these configured forbidden ports will not send out routing packets.
Parameters
vlan <vlan_name 32> − The name of the VLAN on which the router port will be
forbidden.
add | delete – Specify to add or delete ports as forbidden router ports.
<portlist> - Specify a port or range of ports to be configured as forbidden router
ports. The port list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon. Then the highest
switch number, and the highest port number of the range (also separated by a
colon) are specified. The beginning and end of the port list range are
separated by a dash. For example, 1:3 specifies switch number 1, port 3. 2:4
specifies switch number 2, port 4. 1:3-2:4 specifies all of the ports between
switch 1, port 3 and switch 2, port 4 − in numerical order. Non-contiguous
portlist entries are separated by a comma. (ex: 1:1-1:3,1:7-1:9)
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure MLD snooping forbidden multicast router ports:
DGS-3600:4#config mld_snooping mrouter_ports_forbidden default add 1:11-1:20
Command : config mld_snooping mrouter_ports_forbidden default add 1:11-1:20
Success
DGS-3600:4#
config mld_snooping querier
Purpose Used to configure the timers and settings for the MLD snooping querier for the Switch.
Syntax
config mld_snooping querier [vlan <vlan_name 32> | all] {query_interval <sec 1-
65535> | max_response_time <sec 1-25> | robustness_variable <value 1-255> |
last_listener_query_interval <sec 1-25> | state [enable | disable]}
Description This command allows the user to configure the time between general query
transmissions, the maximum time to wait for reports from listeners and the permitted