Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
296
40
DNS COMMANDS
The DNS relay commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following
table.
Command Parameters
config dnsr [[primary | secondary] nameserver <ipaddr> | [add | delete] static
<domain_name 32> <ipaddr>]
enable dnsr {[cache | static]}
disable dnsr {[cache | static]}
show dnsr {static}
Each command is listed, in detail, in the following sections.
config dnsr
Purpose Used to configure the DNS relay function.
Syntax
config dnsr [[primary | secondary] nameserver <ipaddr> | [add |
delete] static <domain_name 32> <ipaddr>]
Description This command is used to configure the DNS relay function on the Switch.
Parameters
primary − Indicates that the IP address below is the address of the
primary DNS server.
secondary − Indicates that the IP address below is the address of the
secondary DNS server.
nameserver <ipaddr> − The IP address of the DNS nameserver.
[add | delete] – Indicates whether to add or delete the DNS relay
function.
<domain_name 32> − The domain name of the entry.
<ipaddr> − The IP address of the entry.
Restrictions Only administrator-level users can issue this command.
Example usage:
To set IP address 10.43.21.12 of primary.
DGS-3600:4#config dnsr primary 10.43.21.12
Command: config dnsr primary 10.43.21.12
Success
DGS-3600:4#
Example usage:
To add an entry domain name dns1, IP address 10.43.21.12 to DNS static table:
DGS-3600:4#config dnsr add static dns1 10.43.21.12
Command: config dnsr add static dns1 10.43.21.12
Success.
DGS-3600:4#
Example usage: