Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
213
config 802.1x auth_parameter
separated by a dash. For example, 1:3 specifies switch number 1, port 3.
2:4 specifies switch number 2, port 4. 1:3-2:4 specifies all of the ports
between switch 1, port 3 and switch 2, port 4 − in numerical order. Non-
contiguous portlist entries are separated by a comma. (ex: 1:1-1:3,1:7-1:9)
all − Specifies all of the ports on the Switch.
default − Returns all of the ports in the specified range to their 802.1x
default settings.
direction [both | in] − Determines whether a controlled port blocks
communication in both the receiving and transmitting directions, or just the
receiving direction.
port_control − Configures the administrative control over the authentication
process for the range of ports. The user has the following authentication
options:
• force_auth − Forces the Authenticator for the port to become
authorized. Network access is allowed.
• auto
−
Allows the port’s status to reflect the outcome of the
authentication process.
• force_unauth − Forces the Authenticator for the port to become
unauthorized. Network access will be blocked.
quiet_period <sec 0-65535> − Configures the time interval between
authentication failure and the start of a new authentication attempt.
tx_period <sec 1-65535> - Configures the time to wait for a response from
a supplicant (user) to send EAP Request/Identity packets.
supp_timeout <sec 1-65535> - Configures the time to wait for a response
from a supplicant (user) for all EAP packets, except for the Request/Identity
packets.
server_timeout <sec 1-65535> - Configure the length of time to wait for a
response from a RADIUS server.
max_req <value 1-10> − Configures the number of times to retry sending
packets to a supplicant (user).
reauth_period <sec 1-65535> − Configures the time interval between
successive re-authentications.
enable_reauth [enable | disable] − Determines whether or not the Switch
will re-authenticate. Enabled causes re-authentication of users at the time
interval specified in the Re-authentication Period field, above.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To configure 802.1x authentication parameters for ports 1 to 20:
DGS-3600:4#config 802.1x auth_parameter ports 1:1–1:20 direction both
Command: config 802.1x auth_parameter ports 1:1–1:20 direction both
Success.
DGS-3600:4#
config 802.1x init
Purpose Used to initialize the 802.1x function on a range of ports.
Syntax
config 802.1x init {port_based ports [<portlist> | all] |
mac_based [ports] [<portlist> | all] {mac_address <macaddr>}]
Description The config 802.1x init command is used to immediately initialize the
802.1x functions on a specified range of ports or for specified MAC