Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
17
DGS-3600:4#save
Command: save
Saving all configurations to NV-RAM... Done.
DGS-3600:4#
reboot
Purpose
Used to restart the Switch.
Syntax reboot
Description
This command is used to restart the Switch.
Parameters
None.
Restrictions
None.
Example usage:
To restart the Switch:
DGS-3600:4#reboot
Command: reboot
Are you sure want to proceed with the system reboot? (y|n)
Please wait, the switch is rebooting...
reset
Purpose
Used to reset the Switch to the factory default settings.
Syntax reset {[config | system]}
Description
This command is used to restore the Switch’s configuration to the default
settings assigned from the factory.
Parameters
config − If the keyword ‘config’ is specified, all of the factory default
settings are restored on the Switch including the IP address, user
accounts, and the switch history log. The Switch will not save or reboot.
system − If the keyword ‘system’ is specified all of the factory default
settings and stacking information are restored on the Switch. The Switch
will save and reboot after the settings are changed to default. Rebooting
will clear all entries in the Forwarding Data Base.
If no parameter is specified, the Switch’s current IP address, user
accounts, and the switch history log are not changed. All other parameters
are restored to the factory default settings. The Switch will not save or
reboot.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To restore all of the Switch’s parameters to its default values:
DGS-3600:4#reset config
Command: reset config
Are you sure to proceed with system reset?(y/n)
Success.
DGS-3600:4#