Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
316
DGS-3600:4# show pim rpset
Command: show pim rpset
PIM RP-Set Table
Bootstrap Router: 12.43.51.81
Group Address RP Address Holdtime Expired Time Type
--------------------- --------------------- ---------------- ------------------- -------------
224.0.0.1/4 31.43.51.81 150 107 Dynamic
Total Entries: 1
DGS-3600:4#
show pim crp
Purpose Used to display the Candidate RP settings on the Switch, along with
CRP parameters configured for the Switch.
Syntax
show pim crp
Description This command will display the settings for Candidate RPs that are
accessible to the switch. This command is for PIM-SM configurations
only.
Parameters None.
Restrictions None.
Usage Example:
To view the CRP settings:
DGS-3600:4# show pim crp
Command: show pim crp
PIM Candidate-RP Table
C-RP Holdtime : 150
C-RP Priority : 2
C-RP Wildcard Prefix Count : 0
Group Interface
--------------------- ---------------------
224.0.0.1/4 Trinity
DGS-3600:4#
config pim cbsr
Purpose Used to configure the settings for the Candidate Bootstrap Router and
the priority of the selected IP interface to become the Boot Strap Router
(BSR) for the PIM-SM network domain.
Syntax
config pim cbsr [ipif <ipif_name 12> {priority [-1 | value 0-255>]} |
hash_masklen <value 0-32> | bootstrap_period <value 1-255>]
Description This command will configure the settings for the Candidate BSR. The
Boot Strap Router holds the information which determines which router
on the network is to be elected as the RP for the multicast group and
then to distribute RP information to other PIM-SM enabled routers. This
command is for PIM-SM configurations only.
Parameters ipif <ipif_name 12> - Enter the ipif name of the interface to become the
CBSR