Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
325
45
MD5 COMMANDS
The MD5 configuration commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
create md5 key <key_id 1-255> <password 16>
config md5 key <key_id 1-255> <password 16>
delete md5 key <key_id 1-255>
show md5 {key <key_id 1-255>}
Each command is listed, in detail, in the following sections.
create md5 key
Purpose Used to create a new entry in the MD5 key table.
Syntax
create md5 key <key_id 1-255> <password 16>
Description This command is used to create an entry for the MD5 key table.
Parameters
<key_id 1-255> − The MD5 key ID. The user may enter a key ranging
from 1 to 255.
<password> − An MD5 password of up to 16 bytes.
Restrictions Only administrator-level users can issue this command.
Usage example
To create an entry in the MD5 key table:
DGS-3600:4# create md5 key 1 dlink
Command: create md5 key 1 dlink
Success.
DGS-3600:4#
config md5 key
Purpose Used to enter configure the password for an MD5 key.
Syntax
config md5 key <key_id 1-255> <password 16>
Description This command is used to configure an MD5 key and password.
Parameters
<key_id 1-255> − The previously defined MD5 key ID.
<password 16> − The user may change the MD5 password for the
md5 key. A new password of up to 16 characters can be created.
Restrictions Only administrator-level users can issue this command.
Usage example
To configure an MD5 Key password: