Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
34
Command Parameters
32>
delete snmp host <ipaddr>
show snmp host <ipaddr>
show snmp v6host {<ipv6addr>}
create trusted_host [<ipaddr> | network <network_address>]
delete trusted_host [<ipaddr> | network <network_address> | all]
show trusted_host <network_address>
enable snmp traps
enable snmp authenticate traps
show snmp traps
disable snmp traps
disable snmp authenticate traps
config snmp system_contact <sw_contact>
config snmp system_location <sw_location>
config snmp system_name <sw_name>
enable rmon
disable rmon
Each command is listed, in detail, in the following sections.
create snmp user
Purpose
Used to create a new SNMP user and adds the user to an SNMP group that is
also created by this command.
Syntax create snmp user <user_name 32> <groupname 32> {encrypted
[by_password auth [md5 <auth_password 8-16> | sha <auth_password
8-20>] priv [none | des <priv_password 8-16>] | by_key auth [md5
<auth_key 32-32> | sha <auth_key 40-40>] priv [none | des <priv_key 32-
32>]]}
Description
The create snmp user command creates a new SNMP user and adds the
user to an SNMP group that is also created by this command. SNMP ensures:
Message integrity − Ensures that packets have not been tampered with during
transit.
Authentication − Determines if an SNMP message is from a valid source.
Encryption − Scrambles the contents of messages to prevent it from being
viewed by an unauthorized source.
Parameters
<user_name 32> − An alphanumeric name of up to 32 characters that will
identify the new SNMP user.
<groupname 32> − An alphanumeric name of up to 32 characters that will
identify the SNMP group with which the new SNMP user will be associated.
encrypted – Allows the user to choose a type of authorization for
authentication using SNMP. The user may choose:
• by_password – Requires the SNMP user to enter a password for
authentication and privacy. The password is defined by specifying
the auth_password below. This method is recommended.
• by_key – Requires the SNMP user to enter a encryption key for
authentication and privacy. The key is defined by specifying the key
in hex form below. This method is not recommended.