Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
55
The download configuration command will initiate the loading of the various settings in the order listed in the configuration file.
When the file has been successfully loaded the message “End of configuration file for DGS-3600” appears followed by the command
prompt.
DGS-3600:4#disable authen_policy
Command: disable authen_policy
Success.
DGS-3600:4#
DGS-3600:4##-------------------------------------------------------------------
DGS-3600:4## End of configuration file for DGS-3600
DGS-3600:4##-------------------------------------------------------------------
DGS-3600:4#
To download a firmware file to the FLASH memory of the Switch:
DGS-3600:4# download firmware_fromTFTP 10.53.13.201 c:\3600firm.had c:\firm1
Command: download firmware_fromTFTP 10.53.13.201 c:\3600firm.had c:\firm1
Connecting to server…………………………..Done.
Download firmware…………………………….Done. Do not power off!
Upload file to FLASH…………………………..Done.
DGS-3600:4#
upload
Purpose Used to upload a configuration file or log file to a TFTP server.
Syntax
upload [cfg_toTFTP [<ipaddr> | <ipv6addr>] <path_filename 64>
{{<drive_id>} <pathname 64>} | log_toTFTP [<ipaddr> | <ipv6addr>]
<path_filename 64> | firmware_toTFTP[<ipaddr> | <ipv6addr>]
<path_filename 64> {{<drive_id>} <pathname 64>} | attack_log_toTFTP
[<ipaddr> | <ipv6addr>] <path_filename 64> {unit <unit_id 1-12>} ]
Description This command is used to upload a configuration file or log file to a TFTP server.
The user now has the option of saving the log or configuration file on the flash
memory located in the Switch using the previously allocated c:/ drive.
Parameters
cfg_toTFTP − Used to upload the current Switch configuration file to a TFTP
server, or to upload a configuration file saved in the Switch’s flash memory to a
TFTP server.
• <ipaddr> − The IP address of the TFTP server.
• <ipv6addr> - The IPv6 address of the TFTP server.
• <path_filename 64> − The DOS path and filename of the configuration
file to be uploaded on the TFTP server. For example, C:\3600.cfg.
• <drive_id> - Enter the drive ID of the internal flash drive to where to
upload the file.
• {<path_filename 64>} – The second path_filename in the command
refers to the flash memory located on the Switch. This drive is
nominated c: and those who wish to save this file to a TFTP server
must enter the path and file name of the configuration file located on
the flash memory of the Switch using this parameter.
log_toTFTP − Used to upload a log file on the Switch to a TFTP server, or to
upload a log file saved in the Switch’s flash memory to a TFTP server.
• <ipaddr> − The IP address of the TFTP server.
• <ipv6addr> - The IPv6 address of the TFTP server.