Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
54
download
Parameters
firmware_fromTFTP − Download and install new firmware on the Switch from a TFTP
server.
• <ipaddr> − The IP address of the TFTP server.
• <ipv6addr> - The IPv6 address of the TFTP server.
• <path_filename 64> − The DOS path and filename of the firmware file on the
TFTP server. For example, C:\3226S.had.
• unit <unitid1-12>- Enter the ID of the Switch in the switch stack to where to
save the file.
• all – Use this parameter to select all switches in the switch stack.
• <drive_id> - Enter the drive ID of the internal flash drive to where to save the
file.
• {<pathname 64>} – The pathname in the command refers to the flash memory
located on the switch. This drive is nominated c: and those who wish to save
the firmware, instead of uploading it directly to the NV-RAM must specify the
path on the flash memory to place this file (ex. c:/firm1). The filename cannot
exceed 64 alphanumeric characters.
• boot_up – Enter this parameter to use this file as the boot up file upon next
reboot of the switch.
config_fromTFTP − Download and install a configuration file on the Switch from a TFTP
server.
• <ipaddr> − The IP address of the TFTP server.
• <ipv6addr> - The IPv6 address of the TFTP server.
• <path_filename 64> − The DOS path and filename of the switch configuration
file on the TFTP server. For example, C:\3226S.had.
• <drive_id> - Enter the drive ID of the internal flash drive to where to save the
file.
• {<path_filename 64>} – The second path_filename in the command refers to
the flash memory located on the switch. This drive is nominated c: and those
who wish to save the firmware, instead of uploading it directly to the NV-RAM
must specify the path on the flash memory to place this file (ex. c:/config1).
The filename cannot exceed 64 alphanumeric characters.
Restrictions Only administrator-level users can issue this command.
Example usage:
To download a configuration file:
DGS-3600:4#download cfg_fromTFTP 10.48.74.121 c:\cfg\setting.txt
Command: download cfg _fromTFTP 10.48.74.121 c:\cfg\setting.txt
Connecting to server................... Done.
Download configuration................. Done.
DGS-3600:4#
DGS-3600:4##-------------------------------------------------------------------
DGS-3600:4## DGS-3600 Configuration
DGS-3600:4##
DGS-3600:4## Firmware: Build 2.20-B35
DGS-3600:4## Copyright(C) 2007 D-Link Corporation. All rights reserved.
DGS-3600:4##-------------------------------------------------------------------
DGS-3600:4#
DGS-3600:4#
DGS-3600:4## BASIC
DGS-3600:4#
DGS-3600:4#config serial_port baud_rate 115200 auto_logout 10_minutes
Command: config serial_port baud_rate 115200 auto_logout 10_minutes