Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
193
DGS-3600:4#config dhcp ping_packets 2
Command: config dhcp ping_packets 2
Success.
DGS-3600:4#
config dhcp ping_timeout
Purpose Used to set the time the Switch will wait before timing out a ping packet.
Syntax
config dhcp ping_timeout <millisecond 500-2000>
Description This command is used set the time the Switch will wait before timing
out a ping packet. If no answer is received, the IP address is
considered unused and may be allocated to a requesting client.
Parameters <millisecond 500-2000> - The user may set a time between 500 and
2000 milliseconds that the Switch will wait before timing out a ping
packet. The default setting is 500 milliseconds.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the Ping timeout:
DGS-3600:4#config dhcp ping_timeout 500
Command: config dhcp ping_timeout 500
Success.
DGS-3600:4#
config dhcp pool boot_file
Purpose Used to specify the Boot File that will be used as the boot image of the
DHCP client
Syntax
config dhcp pool boot_file <pool_name 12> <file_name 64>
Description This command is used to specify the Boot File that will be used as the
boot image of the DHCP client. This image is usually the operating
system that the client uses to load its IP parameters.
Parameters <pool_name 12> - Enter the previously created pool name from which
the boot file will be set.
<file_name 64> - Enter the name of the boot file that will be used for
DHCP clients.
Restrictions Only administrator-level users can issue this command.
Example usage:
To set the boot file:
DGS-3600:4#config dhcp pool boot_file Trinity boot.had
Command: config dhcp pool boot_file Trinity boot.had
Success.
DGS-3600:4#