Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
329
Command: disable ospf
Success.
DGS-3600:4#
show ospf
Purpose Used to display the current OSPF state on the Switch.
Syntax
show ospf
Description This command will display the current state of OSPF on the Switch,
divided into the following categories:
General OSPF settings
OSPF Interface settings
OSPF Area settings
OSPF Virtual Interface settings
OSPF Area Aggregation settings
OSPF Host Route settings
Parameters None.
Restrictions None.
Usage example:
To show OSPF state:
DGS-3600:4#show ospf
Command: show ospf
OSPF Router ID : 10.1.1.2
State : Enabled
OSPF Interface Settings
Interface IP Address Area ID State Link Metric
Status
------------ ------------------ --------- -------- --------- ---------
System 10.90.90.90/8 0.0.0.0 Disabled Link DOWN 1
ip2 20.1.1.1/8 0.0.0.0 Disabled Link DOWN 1
ip3 30.1.1.1/8 0.0.0.0 Disabled Link DOWN 1
Total Entries : 3
OSPF Area Settings
Area ID Type Stub Import Summary LSA Stub Default Cost Translate
--------------- ------ ------------------------------------- -------------------------- ---------------
0.0.0.0 Normal None None None
10.0.0.0 Normal None None None
244.0.0.6 NSSA Enabled 2 Enabled
Total Entries : 3
Virtual Interface Configuration
Transit Virtual Hello Dead Authentication Link
Area ID Neighbor Router Interval Interval Status
----------- --------------- -------- -------- -------------- ------
10.0.0.0 20.0.0.0 10 60 None DOWN
10.1.1.1 20.1.1.1 10 60 None DOWN