Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
139
show lacp_port
Purpose Used to display current LACP port mode settings.
Syntax
show lacp_port {<portlist>}
Description This command will display the LACP mode settings as they are
currently configured.
Parameters <portlist> - Specifies a port or range of ports to be configured. The
port list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon. Then the
highest switch number, and the highest port number of the range
(also separated by a colon) are specified. The beginning and end of
the port list range are separated by a dash. For example, 1:3
specifies switch number 1, port 3. 2:4 specifies switch number 2, port
4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and
switch 2, port 4 − in numerical order. Non-contiguous portlist entries
are separated by a comma. (ex: 1:1-1:3,1:7-1:9) If no parameter is
specified, the system will display the current LACP status for all ports.
Restrictions Only administrator-level users can issue this command.
Example usage:
To display LACP port mode settings:
DGS-3600:4#show lacp_port 1:1-1:10
Command: show lacp_port 1:1-1:10
Port Activity
------ --------
1:1 Active
1:2 Active
1:3 Active
1:4 Active
1:5 Active
1:6 Active
1:7 Active
1:8 Active
1:9 Active
1:10 Active
DGS-3600:4#