Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
347
48
MAC NOTIFICATION COMMANDS
The MAC notification commands in the Command Line Interface (CLI) are listed, in the following table, along with their appropriate
parameters.
Command Parameters
enable mac_notification
disable mac_notification
config mac_notification {interval <int 1-2147483647> | historysize <int 1-500>}
config mac_notification ports [<portlist> | all] [enable | disable]
show mac_notification
show mac_notification ports <portlist>
Each command is listed, in detail, in the following sections.
enable mac_notification
Purpose Used to enable global MAC address table notification on the Switch.
Syntax
enable mac_notification
Description This command is used to enable MAC address notification without
changing configuration.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To enable MAC notification without changing basic configuration:
DGS-3600:4#enable mac_notification
Command: enable mac_notification
Success.
DGS-3600:4#
disable mac_notification
Purpose Used to disable global MAC address table notification on the Switch.
Syntax
disable mac_notification
Description This command is used to disable MAC address notification without
changing configuration.
Parameters None.
Restrictions Only administrator-level users can issue this command.
Example usage:
To disable MAC notification without changing basic configuration: