Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
339
config ospf ipif
hello_interval <sec 1-65535> − Allows the specification of the interval between
the transmission of OSPF Hello packets, in seconds. Between 1 and 65535
seconds can be specified. The Hello Interval, Dead Interval, Authorization Type,
and Authorization Key should be the same for all routers on the same network.
dead_interval <sec 1-65535> − Allows the specification of the length of time
between the receipt of Hello packets from a neighbor router before the selected
area declares that router down. An interval between 1 and 65535 seconds can be
specified. The Dead Interval must be evenly divisible by the Hello Interval.
metric <value 1-65535 > − The interface metric (1 to 65535). Entering a 0 will
allow automatic calculation of the metric.
authentication – Enter the type of authentication preferred. The user may choose
between:
• none – Choosing this parameter will require no authentication.
• simple <password 8> − Choosing this parameter will set a simple
authentication which includes a case-sensitive password of no more
than 8 characters.
• md5 <key_id 1-255> − Choosing this parameter will set authentication
based on md5 encryption. A previously configured MD5 key ID (1 to
255) is required.
metric <value 1-65535> − This field allows the entry of a number between 1 and
65,535 that is representative of the OSPF cost of reaching the selected OSPF
interface. The default metric is 1.
state [enable | disable] – Used to enable or disable this function.
passive [enable | disable] – The user may select Active or Passive for this OSPF
interface. Active interfaces actively advertise OSPF to routers on other Intranets
that are not part of this specific OSPF group. Passive interface will not advertise
to any other routers than those within its OSPF intranet. When this field is
disabled, it denotes an active interface. The default setting is disable. (active)
Restrictions Only administrator-level users can issue this command.
Usage example
To configure OSPF interface settings:
DGS-3600:4#config ospf ipif System priority 2 hello_interval 15 metric 2 state enable
Command: config ospf ipif System priority 2 hello_interval 15 metric 2 state enable
Success.
DGS-3600:4#
show ospf ipif
Purpose Used to display the current OSPF interface settings for the specified
interface name.
Syntax
show ospf ipif {<ipif_name 12> | all}
Description This command will display the current OSPF interface settings for the
specified interface name.
Parameters
<ipif_name 12> − The IP interface name for which to display the current
OSPF interface settings.
all – Choosing this parameter will display the OSPF settings for all IP
interfaces on the Switch.
Restrictions None.
Usage example: