Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
79
config syslog host
local0 − Specifies that local use 0 messages will be sent to the remote
host. This corresponds to number 16 from the list above.
local1 − Specifies that local use 1 messages will be sent to the remote
host. This corresponds to number 17 from the list above.
local2 − Specifies that local use 2 messages will be sent to the remote
host. This corresponds to number 18 from the list above.
local3 − Specifies that local use 3 messages will be sent to the remote
host. This corresponds to number 19 from the list above.
local4 − Specifies that local use 4 messages will be sent to the remote
host. This corresponds to number 20 from the list above.
local5 − Specifies that local use 5 messages will be sent to the remote
host. This corresponds to number 21 from the list above.
local6 − Specifies that local use 6 messages will be sent to the remote
host. This corresponds to number 22 from the list above.
local7 − Specifies that local use 7 messages will be sent to the remote
host. This corresponds to number 23 from the list above.
udp_port <udp_port_number> − Specifies the UDP port number that the
syslog protocol will use to send messages to the remote host.
state [enable | disable] − Allows the sending of syslog messages to the
remote host, specified above, to be enabled and disabled.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To configure a syslog host:
DGS-3600:4#config syslog host 1 severity all facility local0
Command: config syslog host all severity all facility local0
Success.
DGS-3600:4#
Example usage:
To configure a syslog host for all hosts:
DGS-3600:4#config syslog host all severity all facility local0
Command: config syslog host all severity all facility local0
Success.
DGS-3600:4#
delete syslog host
Purpose
Used to remove a syslog host, that has been previously configured, from the
Switch.
Syntax delete syslog host [<index 1-4> | all]
Description
The delete syslog host command is used to remove a syslog host that has
been previously configured from the Switch.
Parameters
<index 1-4> − Specifies that the command will be applied to an index of hosts.
There are four available indexes, numbered 1 through 4.
all − Specifies that the command will be applied to all hosts.
Restrictions
Only administrator-level users can issue this command.