Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
72
Example usage:
To display the current CPU utilization:
DGS-3600:4#show utilization cpu
Command: show utilization cpu
CPU utilization :
--------------------------------------------------------------------------------------------
Five seconds - 15% One minute - 25% Five minutes - 14%
DGS-3600:4#
clear counters
Purpose
Used to clear the Switch’s statistics counters.
Syntax clear counters ports <portlist>
Description
This command will clear the counters used by the Switch to compile
statistics.
Parameters
<portlist> − Specifies a port or range of ports to be displayed. The
port list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon. Then
the highest switch number, and the highest port number of the range
(also separated by a colon) are specified. The beginning and end of
the port list range are separated by a dash. For example, 1:3
specifies switch number 1, port 3. 2:4 specifies switch number 2,
port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and
switch 2, port 4 − in numerical order. Non-contiguous portlist entries
are separated by a comma. (ex: 1:1-1:3,1:7-1:9)
Restrictions
Only administrator-level users can issue this command.
Example usage:
To clear the counters:
DGS-3600:4#clear counters ports 2-9
Command: clear counters ports 1:2-1:9
Success.
DGS-3600:4#
clear log
Purpose
Used to clear the Switch’s history log.
Syntax clear log
Description
This command will clear the Switch’s history log.
Parameters
None.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To clear the log information: