Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
275
show traffic_segmentation
Purpose Used to display the current traffic segmentation configuration on the
Switch.
Syntax
show traffic_segmentation {<portlist>}
Description The show traffic_segmentation command is used to display the
current traffic segmentation configuration on the Switch.
Parameters
<portlist> − Specifies a port or range of ports for which the current
traffic segmentation configuration on the Switch will be displayed.
The port list is specified by listing the lowest switch number and the
beginning port number on that switch, separated by a colon. Then
the highest switch number, and the highest port number of the
range (also separated by a colon) are specified. The beginning and
end of the port list range are separated by a dash. For example, 1:3
specifies switch number 1, port 3. 2:4 specifies switch number 2,
port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and
switch 2, port 4 − in numerical order. Non-contiguous portlist entries
are separated by a comma. (ex: 1:1-1:3,1:7-1:9)
Restrictions The port lists for segmentation and the forward list must be on the
same Switch.
Example usage:
To display the current traffic segmentation configuration on the Switch.
DGS-3600:4#show traffic_segmentation
Command: show traffic_segmentation
Traffic Segmentation Table
Port Forward Portlist
------ --------------------------------------------------
1:1 1-27
1:2 1-27
1:3 1-27
1:4 1-27
1:5 1-27
1:6 1-27
1:7 1-27
1:8 1-27
1:9 1-27
1:10 1-27
1:11 1-27
1:12 1-27
1:13 1-27
1:14 1-27
1:15 1-27
1:16 1-27
1:17 1-27
1:18 1-27
CTRL+C ESC q Quit SPACE n Next Page ENTER Next Entry a All