Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
289
DGS-3600:4#show iproute
Command: show iproute
Routing Table
IP Address/Netmask Gateway Interface Cost Protocol
------------------ -------------- ------------ ------- --------
10.0.0.0/8 0.0.0.0 System 1 Local
Total Entries : 1
DGS-3600:4#
create ipv6route
Purpose Used to create IPv6 route entries to the Switch’s IP routing table.
Syntax
create ipv6route [default | <ipv6networkaddr>] [<ipif_name 12 <ipv6addr>
| <ipv6addr>] {<metric 1-65535>} {[primary | backup]}
Description This command is used to create a primary and backup IP route entry to the
Switch’s IP routing table.
Parameters default – Use this parameter to create a default static IPv6 route entry to the
Switch’s IP routing table.
<ipv6networkaddr> − IPV6 address and netmask of the IP interface that is the
destination of the route. Specify the address and mask information using the
format as ipv6address / prefix_length (ipv6address is hexadecimal number,
prefix length is decimal number, for example 1234::5D7F/32).
ipif_name 12 – Enter the corresponding ipif name of the IPv6 address.
<ipv6addr> − IPv6 address for the next hop router.
<metric 1-65535> − Allows the entry of a routing protocol metric entry,
representing the number of routers between the Switch and the IP address
above. The default setting is 1.
[primary | backup] - The user may choose between Primary and Backup. If the
Primary Static/Default Route fails, the Backup Route will support the entry.
Please take note that the Primary and Backup entries cannot have the same
Gateway.
Restrictions Only administrator-level users can issue this command.
Example usage:
To add a single static IPv6 entry in IPv6 format:
DGS-3600:4#create ipv6route 1234::5D7F/32 2D30::AC21
Command:create ipv6route 1234::5D7F/32 2D30::AC21
Success.
DGS-3600:4#
delete ipv6route
Purpose Used to delete an static IPv6 route entry from the Switch’s IP routing table.
Syntax
delete ipv6route [[default | <ipv6networkaddr>] [<ipif_name 12>
<ipv6addr> | <ipv6addr>] | all]
Description This command will delete an existing static IPv6 entry from the Switch’s IP
routing table.