Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
335
create ospf aggregation
• advertise [enable | disable] − Allows for the advertisement
trigger to be enabled or disabled.
Restrictions Only administrator-level users can issue this command.
Usage example:
To create an OSPF area aggregation:
DGS-3600:4#create ospf aggregation 10.1.1.1 10.48.76.122/16
lsdb_type summary advertise enable
Command: create ospf aggregation 10.1.1.1 10.48.76.122/16
lsdb_type summary advertise enable
Success.
DGS-3600:4#
delete ospf aggregation
Purpose Used to delete an OSPF area aggregation configuration.
Syntax
delete ospf aggregation <area_id> <network_address> lsdb_type
[summary | nssa_ext]
Description This command is used to delete an OSPF area aggregation configuration.
Parameters
<area_id> − A 32-bit number in the form of an IP address (xxx.xxx.xxx.xxx)
that uniquely identifies the OSPF area in the OSPF domain.
<network_address> − The 32-bit number in the form of an IP address that
uniquely identifies the network that corresponds to the OSPF Area.
lsdb_type summary − Specifies the type of address aggregation to be
deleted. Choose either summary or nssa_ext.
Restrictions Only administrator-level users can issue this command.
Usage example
To configure the OSPF area aggregation settings:
DGS-3600:4#delete ospf aggregation 10.1.1.1 10.48.76.122/16 lsdb_type summary
Command: delete ospf aggregation 10.1.1.1 10.48.76..122/16 lsdb_type summary
Success.
DGS-3600:4#
config ospf aggregation
Purpose Used to configure the OSPF area aggregation settings.
Syntax
config ospf aggregation <area_id> <network_address> lsdb_type
[summary {advertise [enable | disable]} | nssa_ext {advertise [enable
| disable]}]
Description This command is used to configure the OSPF area aggregation settings.
Parameters
<area_id> − A 32-bit number in the form of an IP address
(xxx.xxx.xxx.xxx) that uniquely identifies the OSPF area in the OSPF
domain.
<network_address> − The 32-bit number in the form of an IP address that