Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
250
config flow_meter profile_id
• ebs <value 1-16384> - Excess Burst Size. Measured in bytes, the EBS is
associated with the CIR and is used to identify packets that exceed the
boundaries of the CBS packet size. The EBS is to be configured for an
equal or larger rate than the CBS. Packet flows that exceed this value are
marked as red.
conform - This field denotes the green packet flow. Green packet flows may have
their DSCP field rewritten to a value stated in this field. Users may also choose to
count green packets by checking the Counter check box.
• permit – Enter this parameter to allow packet flows that are in the green
flow.
• replace_dscp <value 0-63> - Packets that are in the green flow may have
their DSCP field rewritten using this parameter and entering the DSCP
value to replace.
• counter [enable | disable] – Use this parameter to enable or disable the
packet counter for the specified ACL entry in the green flow.
exceed - This field denotes the yellow packet flow. Yellow packet flows may have
excess packets permitted through or dropped. Users may replace the DSCP field of
these packets by checking its radio button and entering a new DSCP value in the
allotted field.
• permit – Enter this parameter to allow packet flows that are in the yellow
flow.
• replace_dscp <value 0-63> - Packets that are in the yellow flow may have
their DSCP field rewritten using this parameter and entering the DSCP
value to replace.
• drop – Enter this parameter to drop packets that are in the yellow flow.
• counter [enable | disable] – Use this parameter to enable or disable the
packet counter for the specified ACL entry in the yellow flow.
violate - This field denotes the red packet flow. Red packet flows may have excess
packets permitted through or dropped. Users may replace the DSCP field of these
packets by checking its radio button and entering a new DSCP value in the allotted
field.
• permit – Enter this parameter to allow packet flows that are in the red flow.
• replace_dscp <value 0-63> - Packets that are in the red flow may have
their DSCP field rewritten using this parameter and entering the DSCP
value to replace.
• drop – Enter this parameter to drop packets that are in the red flow.
• counter [enable | disable] – Use this parameter to enable or disable the
packet counter for the specified ACL entry in the red flow.
delete – Use this parameter to delete the specified flow meter.
Restrictions Only administrator-level users can issue this command. Only 2 counters may be
enabled at any given time.
Example usage:
To enable the sFlow function:
DGS-3600:4#config flow_meter profile_id 1 access_id 1 tr_tcm cir 1000 cbs
200 pir 2000 pbs 200 exceed replace_dscp 21 violate drop
Command: config flow_meter profile_id 1 access_id 1 tr_tcm cir 1000 cbs 200
pir 2000 pbs 200 exceed replace_dscp 21 violate drop
Success.
DGS-3600:4#