Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
349
DGS-3600:4#config mac_notification ports 7 enable
Command: config mac_notification ports 7 enable
Success.
DGS-3600:4#
show mac_notification
Purpose Used to display the Switch’s MAC address table notification global
settings
Syntax
show mac_notification
Description This command is used to display the Switch’s MAC address table
notification global settings.
Parameters None.
Restrictions None.
Example usage:
To view the Switch’s MAC address table notification global settings:
DGS-3600:4#show mac_notification
Command: show mac_notification
Global Mac Notification Settings
State : Enabled
Interval : 1
History Size : 1
DGS-3600:4#
show mac_notification ports
Purpose Used to display the Switch’s MAC address table notification status
settings
Syntax
show mac_notification ports <portlist>
Description This command is used to display the Switch’s MAC address table
notification status settings.
Parameters <portlist> - Specify a port or group of ports to be viewed. The port list is
specified by listing the lowest switch number and the beginning port
number on that switch, separated by a colon. Then the highest switch
number, and the highest port number of the range (also separated by a
colon) are specified. The beginning and end of the port list range are
separated by a dash. For example, 1:3 specifies switch number 1, port
3. 2:4 specifies switch number 2, port 4. 1:3-2:4 specifies all of the
ports between switch 1, port 3 and switch 2, port 4 − in numerical
order. Non-contiguous portlist entries are separated by a comma. (ex:
1:1-1:3,1:7-1:9)
Entering this command without the parameter will display the MAC
notification table for all ports.
Restrictions None.
Example usage:
To display all port’s MAC address table notification status settings: