Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
19
show module_info
Purpose To show information concerning the added uplink module.
Syntax
show module_info
Description This command is used to view information about the DEM-410X and
DEM-410CX uplink modules added to an xStack DGS-3600 series.
The following explains what is presented in the window:
Box ID – The ID of the switch in the switch stack.
Module Name – The name of the optional module. Currently,
switches in the xStack DGS-3600 series only support the DEM-410X
and the DEM-410CX optional modules.
Rev. – The hardware revision of the optional module.
Serial No. – The serial number associated with this particular
optional module.
Description – A brief description of the optional module including port
count and module type.
Parameters None.
Restrictions None.
Example usage:
To view information concerning the optional module added to an xStack DGS-3600 Series switch.
DGS-3600:4#show module_info
Command: show module_info
ID Module Name Rev. Serial Description
No.
------ ------------------ ------- --------- -------------------------------------------
1 DEM-410X 2A1 123456789 1-Port 10GE XFP Uplink Module
2 DEM-410CX 1A1 123454567 1-Port 10GE CX4 Uplink Module
DGS-3600:4#
config command_prompt
Purpose Used to configure the command prompt for the Command Line
Interface.
Syntax
config command_prompt [<string 16> | username | default]
Description This command is used to configure the command prompt for the CLI
interface of the Switch. The current command prompt consists of
“product name + : + user level + product name” (ex. DGS-3600:4#). The
user may replace all parts of the command prompt, except the # by
entering a string of 16 alphanumerical characters with no spaces, or the
user may enter the current login username configured on the Switch.
Parameters <string 16> - Enter an alphanumeric string of no more than 16
characters to define the command prompt for the CLI interface.
username – Entering this parameter will replace the current CLI
command prompt with the login username configured on the Switch.
default – Entering this parameter will return the command prompt to its
original factory default setting.
Restrictions The reset command will not alter the configured command prompt, yet
the reset system command will return the command prompt to its
original factory default setting.