Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
348
DGS-3600:4#disable mac_notification
Command: disable mac_notification
Success.
DGS-3600:4#
config mac_notification
Purpose Used to configure MAC address notification.
Syntax
config mac_notification {interval <int 1-2147483647> | historysize
<int 1-500>}
Description MAC address notification is used to monitor MAC addresses learned
and entered into the FDB.
Parameters interval <sec 1-2147483647> - The time in seconds between
notifications. The user may choose an interval between 1 and
2,147,483,647 seconds.
historysize <1-500> - The maximum number of entries listed in the
history log used for notification.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the Switch’s MAC address table notification global settings:
DGS-3600:4#config mac_notification interval 1 historysize 500
Command: config mac_notification interval 1 historysize 500
Success.
DGS-3600:4#
config mac_notification ports
Purpose Used to configure MAC address notification status settings.
Syntax
config mac_notification ports [<portlist> | all] [enable | disable]
Description MAC address notification is used to monitor MAC addresses learned
and entered into the FDB.
Parameters <portlist> - Specify a port or range of ports to be configured. The port
list is specified by listing the lowest switch number and the beginning
port number on that switch, separated by a colon. Then the highest
switch number, and the highest port number of the range (also
separated by a colon) are specified. The beginning and end of the port
list range are separated by a dash. For example, 1:3 specifies switch
number 1, port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4
specifies all of the ports between switch 1, port 3 and switch 2, port 4 −
in numerical order. Non-contiguous portlist entries are separated by a
comma. (ex: 1:1-1:3,1:7-1:9)
all – Entering this command will set all ports on the system.
[enable | disable] – These commands will enable or disable MAC
address table notification on the Switch.
Restrictions Only administrator-level users can issue this command.
Example usage:
To enable port 7 for MAC address table notification: