Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
138
Example usage:
To display Link Aggregation configuration:
DGS-3600:4#show link_aggregation
Command: show link_aggregation
Link Aggregation Algorithm = MAC-source-dest
Group ID : 1
Type : TRUNK
Master Port : 1:18
Member Port : 1:18,1:20,1:22,1:24
Active Port :
Status : Disabled
Flooding Port : 5
DGS-3600:4#
config lacp_ports
Purpose Used to configure settings for LACP compliant ports.
Syntax
config lacp_ports <portlist> mode [active | passive]
Description This command is used to configure ports that have been previously designated
as LACP ports (see create link_aggregation).
Parameters
<portlist> − Specifies a port or range of ports to be configured. The port list is
specified by listing the lowest switch number and the beginning port number
on that switch, separated by a colon. Then the highest switch number, and the
highest port number of the range (also separated by a colon) are specified.
The beginning and end of the port list range are separated by a dash. For
example, 1:3 specifies switch number 1, port 3. 2:4 specifies switch number 2,
port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3 and switch 2,
port 4 − in numerical order. Non-contiguous portlist entries are separated by a
comma. (ex: 1:1-1:3,1:7-1:9)
mode – Select the mode to determine if LACP ports will process LACP control
frames.
• active – Active LACP ports are capable of processing and sending
LACP control frames. This allows LACP compliant devices to
negotiate the aggregated link so the group may be changed
dynamically as needs require. In order to utilize the ability to change
an aggregated port group, that is, to add or subtract ports from the
group, at least one of the participating devices must designate LACP
ports as active. Both devices must support LACP.
• passive – LACP ports that are designated as passive cannot process
LACP control frames. In order to allow the linked port group to
negotiate adjustments and make changes dynamically, at one end of
the connection must have “active” LACP ports (see above).
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure LACP port mode settings:
DGS-3600:4#config lacp_port 1:1-1:12 mode active
Command: config lacp_port 1:1-1:12 mode active
Success.
DGS-3600:4#