Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
315
DGS-3600:4#show pim static_rp
Command: show pim static_rp
PIM Static RP Table
Group RP Address
------------------ ---------------------
224.0.0.1/4 11.1.1.254
239.0.0.1/32 31.1.1.1
239.0.0.2/32 31.1.1.12
239.0.0.3/32 31.1.1.123
Total entries: 4
DGS-3600:4#
config pim last_hop_spt_switchover
Purpose Used to configure the packet threshold that the last hop router in the RP
tree will use to change its path to a SPT.
Syntax
config pim last_hop_spt_switchover [never | immediately]
Description This command will configure the need to change the last hop router’s
distribution tree to a SPT. The last hop router will always receive data
from the shared tree unless this command is changed to immediately
and then the router will always receive multicast data from the shortest
path tree. This command is for PIM-SM configurations only.
Parameters never – Using this command will configure the router to always receive
multicast data from the shared tree.
immediately – Using this command will configure the router to always
receive multicast data from the shortest path tree.
Restrictions Only administrator-level users can issue this command.
Usage example:
To configure the last hop router to never enter an SPT:
DGS-3600:4#config pim last_hop_spt_switchover immediately
Command: config pim last_hop_spt_switchover immediately
Success.
DGS-3600:4#
show pim rpset
Purpose Used to display the RP Set of the Switch.
Syntax
show pim rpset
Description This command will display the information regarding the RP Set learned
by the BSR. This command is for PIM-SM configurations only.
Parameters None.
Restrictions None.
Usage example:
To view the RP Set information: