Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
265
config time_zone
Purpose Used to determine the time zone used in order to adjust the system
clock.
Syntax
config time_zone {operator [+ | -] | hour <gmt_hour 0-13> | min
<minute 0-59>}
Description This will adjust system clock settings according to the time zone.
Time zone settings will adjust SNTP information accordingly.
Parameters operator – Choose to add (+) or subtract (-) time to adjust for time
zone relative to GMT.
hour – Select the number of hours different from GMT.
min – Select the number of minutes difference added or subtracted
to adjust the time zone.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure time zone settings:
DGS-3600:4#config time_zone operator + hour 2 min 30
Command: config time_zone operator + hour 2 min 30
Success.
DGS-3600:4#
config dst
Purpose Used to enable and configure time adjustments to allow for the use of
Daylight Savings Time (DST).
Syntax
config dst [disable | repeating {s_week <start_week 1-4,last> | s_day
<start_day sun-sat> | s_mth <start_mth 1-12> | s_time start_time
hh:mm> | e_week <end_week 1-4,last> | e_day <end_day sun-sat> |
e_mth <end_mth 1-12> | e_time <end_time hh:mm> | offset [30 | 60 | 90
| 120]} | annual {s_date start_date 1-31> | s_mth <start_mth 1-12> |
s_time <start_time hh:mm> | e_date <end_date 1-31> | e_mth
<end_mth 1-12> | e_time <end_time hh:mm> | offset [30 | 60 | 90 |
120]}]
Description DST can be enabled and configured using this command. When enabled
this will adjust the system clock to comply with any DST requirement. DST
adjustment effects system time for both manually configured time and time
set using SNTP service.
Parameters disable - Disable the DST seasonal time adjustment for the Switch.
repeating - Using repeating mode will enable DST seasonal time
adjustment. Repeating mode requires that the DST beginning and ending
date be specified using a formula. For example, specify to begin DST on
Saturday during the second week of April and end DST on Sunday during
the last week of October.
annual - Using annual mode will enable DST seasonal time adjustment.
Annual mode requires that the DST beginning and ending date be specified
concisely. For example, specify to begin DST on April 3 and end DST on
October 14.