Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
122
config vlan add
Purpose Used to add additional ports to a previously configured VLAN.
Syntax
config vlan <vlan_name 32> {[add [ tagged | untagged |
forbidden] <portlist> | advertisement [enable | disable]}
Description This command is used to add ports to the port list of a previously
configured VLAN. Additional ports may be specified as tagging,
untagging, or forbidden. The default is to assign the ports as
untagging.
Parameters
<vlan_name 32> − The name of the VLAN to add or delete ports to.
add − Specifies which ports to add. The user may also specify if the
ports are:
• tagged − Specifies the additional ports as tagged.
• untagged − Specifies the additional ports as untagged.
• forbidden − Specifies the additional ports as forbidden.
<portlist> − A port or range of ports to add to the VLAN. The port list is
specified by listing the lowest switch number and the beginning port
number on that switch, separated by a colon. Then the highest switch
number, and the highest port number of the range (also separated by
a colon) are specified. The beginning and end of the port list range
are separated by a dash. For example, 1:3 specifies switch number 1,
port 3. 2:4 specifies switch number 2, port 4. 1:3-2:4 specifies all of
the ports between switch 1, port 3 and switch 2, port 4 − in numerical
order. Non-contiguous portlist entries are separated by a comma. (ex:
1:1-1:3,1:7-1:9)
advertisement [enable | disable] − Enables or disables GVRP on the
specified VLAN.
Restrictions Only administrator-level users can issue this command.
Example usage:
To add 4 through 8 of module 2 as tagged ports to the VLAN v1:
DGS-3600:4#config vlan v1 add tagged 1:4-1:8
Command: config vlan v1 add tagged 1:4-1:8
Success.
DGS-3600:4#
Note: The current firmware version requires the user to manually
configure the PVID for untagged ports or the host may not connect to the
Switch correctly.
config vlan delete
Purpose Used to delete ports from a previously configured VLAN.
Syntax
config vlan <vlan_name 32> delete <portlist>
Description This command is used to delete ports from the port list of a previously
configured VLAN.
Parameters
<vlan_name 32> − The name of the VLAN from which to delete ports.
<portlist> − A port or range of ports to delete from the VLAN. The port