Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
276
36
ARP COMMANDS
The ARP commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table.
Command Parameters
create arpentry <ipaddr> <macaddr>
delete arpentry [<ipaddr> | all]
show arpentry {ipif <ipif_name 12> | ipaddress <ipaddr> | static}
config arp_aging time <value 0-65535>
clear arptable
config arpentry <ipaddr> <macaddr>
Each command is listed, in detail, in the following sections.
create arpentry
Purpose Used to make a static entry into the ARP table.
Syntax
create arpentry <ipaddr> <macaddr>
Description This command is used to enter an IP address and the
corresponding MAC address into the Switch’s ARP table.
Parameters
<ipaddr> − The IP address of the end node or station.
<macaddr> − The MAC address corresponding to the IP address
above.
Restrictions Only administrator-level users can issue this command. The Switch
supports up to 255 static ARP entries.
Example usage:
To create a static ARP entry for the IP address 10.48.74.121 and MAC address 00:50:BA:00:07:36:
DGS-3600:4#create arpentry 10.48.74.121 00-50-BA-00-07-36
Command: create arpentry 10.48.74.121 00-50-BA-00-07-36
Success.
DGS-3600:4#
delete arpentry
Purpose Used to delete a static entry into the ARP table.
Syntax
delete arpentry {[<ipaddr> | all]}
Description This command is used to delete a static ARP entry, made using the
create arpentry command above, by specifying either the IP
address of the entry or all. Specifying all clears the Switch’s ARP
table.
Parameters
<ipaddr> − The IP address of the end node or station.
all − Deletes all ARP entries.
Restrictions Only administrator-level users can issue this command.
Example Usage: