Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
163
22
IGMP SNOOPING COMMANDS
The IGMP Snooping commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command Parameters
config igmp_snooping [vlan <vlan_name 32> | all] {host_timeout <sec 1-16711450> |
router_timeout <sec 1-16711450> | leave_timer <sec 1-
16711450> | state [enable | disable] | fast_leave [enable |
disable]}
config igmp_snooping querier [vlan <vlan_name 32> | all] {query_interval <sec 1-65535> |
max_response_time <sec 1-25> | robustness_variable <value 1-
255> | last_member_query_interval <sec 1-25> | state [enable |
disable]}
config router_ports <vlan_name 32> [add | delete] <portlist>
config router_ports_forbidden <vlan_name 32> [add | delete] <portlist>
enable igmp_snooping {forward_mcrouter_only}
show igmp_snooping {vlan <vlan_name 32>}
disable igmp_snooping {forward_mcrouter_only}
show igmp snooping group {vlan <vlan_name 32>}
show router_ports {vlan <vlan_name 32>} {[static | dynamic| forbidden]}
show igmp_snooping forwarding {vlan <vlan_name 32>}
create igmp_snooping multicast_vlan <vlan_name 32> <vlanid 2-4094>
config igmp_snooping multicast_vlan <vlan_name 32> {member_port <portlist> | source_port <portlist>
| state [enable | disable] | replace_source_ip <ipaddr>
delete igmp_snooping multicast_vlan <vlan_name 32>
show igmp_snooping multicast_vlan {<vlan_name 32>}
config igmp_snooping multicast_vlan_group <vlan_name 32> [add multicast_range <range_name 32> | delete
multicast_range [<range_name 32> | all]]
show igmp_snooping multicast_vlan_group {<vlan_name 32>}
Each command is listed, in detail, in the following sections.
config igmp_snooping
Purpose Used to configure IGMP snooping on the Switch.
Syntax
config igmp_snooping [vlan <vlan_name 32> | all] {host_timeout <sec 1-
16711450> | router_timeout <sec 1-16711450> | leave_timer <sec 1-
16711450> | state [enable | disable]} | fast_leave [enable | disable]}
Description This command allows users to configure IGMP snooping on the Switch.
Parameters
vlan <vlan_name 32> − The name of the VLAN for which IGMP snooping is to
be configured.
host_timeout <sec 1-16711450> − Specifies the maximum amount of time a
host can be a member of a multicast group without the Switch receiving a host
membership report. The default is 260 seconds.
router_timeout <sec 1-16711450> − Specifies the maximum amount of time a
route can be a member of a multicast group without the Switch receiving a