Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
16
Example usage:
To enable HTTP and configure port number:
DGS-3600:4#enable web 80
Command: enable web 80
Success.
DGS-3600:4#
disable web
Purpose
Used to disable the HTTP-based management software on the Switch.
Syntax disable web
Description
This command disables the Web-based management software on the
Switch.
Parameters
None.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To disable HTTP:
DGS-3600:4#disable web
Command: disable web
Success.
DGS-3600:4#
save
Purpose
Used to save changes in the Switch’s configuration to non-volatile RAM.
Syntax save {[config {<drive_id>} <pathname 64> | log | all]}
Description
This command is used to enter the current switch configuration or log
file into non-volatile RAM. The saved switch configuration will be loaded
into the Switch’s memory each time the Switch is restarted.
Parameters
config <drive_id> – Specify to save current settings to the Flash
memory of the switch.
<drive_id> - Specify the ID of the drive where the log or configuration
file will be placed.
<pathname 64> - Enter a name of up to 64 characters to define the file
to be saved on the flash drive.
log – Specify to save current Switch log to NV-RAM.
all – Use to save the configuration and log file to NV-RAM.
Restrictions
Only administrator-level users can issue this command.
Example usage:
To save the Switch’s current configuration to non-volatile RAM: