Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
269
DGS-3600:4#create policy_route name manager
Command: create policy_route name manager
Success.
DGS-3600:4#
config policy_route
Purpose Used to configure the parameters to set the policy route on the Switch.
Syntax
config policy_route name <policyroute_name 32> acl profile_id <value 1-14> |
access_id <value 1-128> | nexthop <ipaddr> | state [enable | disable]
Description This command is used to configure the policy route settings for a policy route
created with the create policy_route command. The administrator must have
previously created an access profile with an accompanying access rule using the
create access_profile profile_id and config access_profile profile_id
mentioned previously in this manual. The next hop router IP address must also be
specified using this command.
Parameters name <policyroute_name 32> - Enter an alphanumeric name of no more than 32
characters which identifies this policy route.
acl – This parameter is used to denote the access profile that will be used with this
command, by identifying the following parameters:
• profile_id <value 1-14> - Enter the ID number of the previously created
access profile that is to be associated with this policy route.
• access_id <value 1-128> - Enter the previously created access ID that
has been created in conjunction with the access profile ID mentioned
previously, that is to be associated with this policy route.
nexthop <ipaddr> - Enter the IP address of the net hop router that will be
connected to the gateway router. This field must be set or no policy routing will take
place.
state [enable | disable] – Used to enable or disable this policy route on the Switch.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the policy route name “manager”:
DGS-3600:4#config policy_route name manager acl profile_id 1 access_id 2 next
hop 10.2.2.2 state enable
Command: config policy_route name manager acl profile_id 1 access_id 2 next
hop 10.2.2.2 state enable
Success.
DGS-3600:4#
delete policy_route
Purpose Used to delete a policy route setting.
Syntax
delete policy_route name <policyroute_name 32>
Description This command is used to delete a policy route setting.
Parameters name <policyroute_name 32> - Enter an alphanumeric name of no more than 32
characters to identify this policy route to be deleted.
Restrictions Only administrator-level users can issue this command.