Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
320
show pim ipmroute
Purpose Used to display the PIM IP Multicast Route Table on the Switch.
Syntax
show pim ipmroute
Description This command will display the PIM IP Multicast Route Table on the
Switch. This command is for PIM-SM configurations only.
Parameters None.
Restrictions None.
Usage example:
To view the PIM routes:
DGS-3600:4# show pim ipmroute
Command: show pim ipmroute
PIM IP Multicast Route Table
UA = Upstream AssertTimer
AM = Assert Metric
AMPref = Assert MetricPref
ARB = Assert RPTBit
Group Address Source Address UA AM AMPref ARB Flag Type
------------------ ------------------ ------ ------ ------ ------ ---- -------
224.0.1.1 31.43.51.81/32 0 0 0 0 RPT (*.G)
224.0.1.24 10.54.81.250/32 0 0 0 0 SPT (S.G)
224.0.1.24 10.55.68.64/32 0 0 0 0 SPT (S.G)
224.0.1.24 31.43.51.81/32 0 0 0 0 RPT (*.G)
229.55.150.208 10.6.51.1/32 0 0 0 0 SPT (S.G)
229.55.150.208 10.38.45.151/32 0 0 0 0 SPT (S.G)
229.55.150.208 10.38.45.192/32 0 0 0 0 SPT (S.G)
229.55.150.208 10.50.93.100/32 0 0 0 0 SPT (S.G)
229.55.150.208 10.51.16.1/32 0 0 0 0 SPT (S.G)
229.55.150.208 10.59.23.10/32 0 0 0 0 SPT (S.G)
229.55.150.208 31.43.51.81/32 0 0 0 0 RPT (*.G)
239.192.0.1 31.43.51.81/32 0 0 0 0 RPT (*.G)
Total Entries: 12
DGS-3600:4#
create pim register_checksum_include_data
Purpose Used to set the RPs that the Switch will send Register packets to and
create checksums to be included with the data in Registered packets.
Syntax
create pim register_checksum_include_data rp_ address <ipaddr>
Description This command will set the RPs that the Switch will send Register packets
to and create checksums to be included with the data in Registered
packets. This command is for PIM-SM configurations only.
Parameters rp_address <ipaddr> - Enter the IP address of the RP that will verify
checksums included with Registered packets.
Restrictions Only administrator-level users can issue this command.
Usage example:
To create an RP to which the Switch will send Register packets to and create checksums to be included with the data in
Registered packets: