Filter
Top Products
xStack DGS-3600 Series Layer 3 Gigabit Ethernet Managed Switch CLI Manual
345
config route preference
Purpose Used to configure the route preference of each route type.
Syntax
config route preference [static | rip | ospfIntra | ospfInter |
ospfExt1 | ospfExt2] <value 1-999>
Description This command is used to set the route preference value for each
routing protocol listed. A lower value will denote a better chance that
the specified protocol is the best path for routing packets.
Parameters The user may set a preference value for a specific route by first
choosing one of the following and then adding an alternate
preference value:
• static – Choose this parameter to configure the preference
value for the static route.
• rip - Choose this parameter to configure the preference
value for the RIP route.
• ospfIntra - Choose this parameter to configure the
preference value for the OSPF Intra-area route.
• ospfInter - Choose this parameter to configure the
preference value for the OSPF Inter-area route.
• ospfExtT1 - Choose this parameter to configure the
preference value for the OSPF AS External route type-1
route.
• ospfExtT2 - Choose this parameter to configure the
preference value for the AS External route type-2 route.
<value 1-999> - Enter a value between 1 and 999 to set the route
preference for a particular route. The lower the value, the higher the
chance the specified protocol will be chosen as the best path for
routing packets.
Restrictions Only administrator-level users can issue this command.
Example usage:
To configure the route preference value for RIP as 50:
DGS-3600:4#config route preference rip 50
Command: config route preference rip 50
Success.
DGS-3600:4#
show route preference
Purpose Used to display the route preference of each route type.
Syntax
show route preference {[local | static | rip | ospfIntra | ospfInter |
ospfExt1 | ospfExt2]}
Description This command will display the Route Preference Settings table. The
user may view all route preference settings by entering the
command without any parameters or choose a specific type by
adding the route parameter to the command.
Parameters local – Enter this parameter to view the route preference settings for
the local route.
static - Enter this parameter to view the route preference settings for
the static route.
rip - Enter this parameter to view the route preference settings for