Filter
Top Products
1
crossPortTest
1-103
Telnet Commands
Example To execute a functional test of all the ports on a switch 100 times:
switch:admin> crossporttest
Running Cross Port Test .... passed.
Diagnostics Below are possible error messages if failures are detected:
0x20 ERR_STAT_ENCIN
0x21 ERR_STAT_CRC
0x22 ERR_STAT_TRUNC
0x23 ERR_STAT_2LONG
0x24 ERR_STAT_BADEOF
0x25 ERR_STAT_ENCOUT
0x26 ERR_STAT_BADOS
0x27 ERR_STAT_C3DISC
0x28 ERR_STAT
0x29 XMIT
0x2a PORT_M2M
0x2b PORT_ABSENT
0x2c PORT_DIED
0x2d PORT_ENABLE
0x2e PORT_STOPPED
-gbic_mode mode
The gbic_mode parameter may be used to
override the global GBIC mode described
above for the duration of this test. Specify 1
enable gbic_mode, and the testing is limited
to user ports with GBICs or SFPs installed.
-no_restore nr_mode
The nr_mode parameter may be set in order
to force the test to skip part of the post-test
cleanup normally performed. This may be
helpful during debug. This parameter
should normally be left at the default value
of 0.
-ports list
A list of user ports to test. By default all of
the user ports in the current switch will be
tested. This option may be used to restrict
testing to the specified ports.