EMC DS-32B2 Switch User Manual


 
1
1-150
EMC Connectrix DS-32B2 and ED-12000B Fabric OS Reference Manual
Telnet Commands
fastboot
Reboot the switch, bypassing POST.
Syntax
fastboot
Availability Admin
Description Use this command to reboot the switch, bypassing POST. The reboot
takes effect immediately as the switch resets and executes normal
power-up booting sequence. However, power on self test (POST) is
skipped. This reduces boot time significantly.
If POST has been disabled using the
diagDisablePost command,
then
fastboot is the same as reboot. However, fastboot skips
POST on the current reboot, while
diagDisablePost skips POST on
all future reboots until cancelled by
diagEnablePost.
Because
fastboot reboots the CP a WARNING message and a
confirmation is displayed. The command only takes place if the user
responds positively.
For the ED-12000B, the fastboot command will reboot both logical
switches and both CPs.
Operands None
Example
To reboot the switch, bypassing POST:
switch:admin>fastboot
Warning: This command is being run on a control processor (CP)
based system and will cause the active CP to reboot. This will
cause disruption to devices attached to both switch 0 and switch 1.
To just reboot a logical switch on this system, use command
switchreboot(1M) on the logical switch you intend to reboot.
Are you sure you want to reboot the active CP [y/n]?y
See Also diagDisablePost
diagEnablePost
reboot