EMC DS-32B2 Switch User Manual


 
1
agtcfgSet
1-11
Telnet Commands
agtcfgSet
Modify the SNMP agent configuration.
Syntax
agtcfgSet
Availability Admin
Description Use this command to modify the configuration of the SNMP agent in
the switch. Set the values for the following items.
There is one agent per logical switch. This command is specific to the logical
switch you are logged into.
sysDescr The system description. The default value is Fibre
Channel Switch.
sysLocation The location of the system. The default value is
End User Premise.
sysContact The contact information for the system. The
default value is
Field Support.
swEventTrapLevel The event trap level in conjunction with
the events severity level. When an event occurs and if its severity
level is at or below the set value, the SNMP traap, swEventTrap,
is sent to configure trap recipients. The default value is 0 (off),
implying that no swEventTrap is sent. Possible values are:
0 none
1 critical
2 error
3 warning
4 informational
5 debug
authTraps The default value is 0 (off). When enabled the
authentication trap, authentication Failure, is transmitted to a
configured trap recipient in the event the agent received a
protocol message that is not properly authenticated. In the
context of SNMPv1 and SNMPv2c, this means that a request
contains a community string that is not known to the agent. The
default value for this parameter is 0 (disabled).