Filter
Top Products
1
1-108
EMC Connectrix DS-32B2 and ED-12000B Fabric OS Reference Manual
Telnet Commands
diagClearError
Clear the diag software flag to allow for retest.
Syntax
diagclearerror [[-slot] slot][-switch switch] | -all
Availability Admin
Description Use this command to clear the diag software flag that indicates
whether a port is BAD or OK. The current flag settings are displayed
by using the
diagShow command. This command resets the flag to
allow the bad port to be retested; otherwise the test will skip the port.
This command does not clear the error log entry. Instead, it generates
the
DIAG-CLEAR_ERR message for each port software flag cleared. For
example, the following message is for a diagnostic error cleared from
port 3:
0x10f9d560 (tShell): Apr 9 08:35:50
Error DIAG-CLEAR_ERR, 3,
Pt13 (Lm3) Diagnostics Error Cleared
Err# 0001
Operands This command has the following operands:
Example
To clear the diag software flag:
switch:admin> > diagclearerror 1
0x1bcb (fabos): Switch: 0, Error DIAG-CLEARERR, 3,
Pt5 Sl1 Ch0 Qd1 Diagnostics Error Cleared
Err# 0120041 0105
See Also diagShow
slot
Specify the port where you want to clear diagnostic
error messages. This operand is for v3.0 only. This
operand is optional.
-slot slot
Specify the slot to clear the diagnostic failure status.
This operand is for v4.0 only. This operand is
optional.
-switch
switch
Specify the logical switch number to operate on. If
omitted, then all blades will be cleared. This operand
is for v4.0 only. This operand is optional.
-all
If specified, all blades will be cleared. This operand is
for v4.0 only.