Filter
Top Products
1
spinSilk
1-417
Telnet Commands
Operands This command has the following operands:
nmill
Specify the number of million frames to send. The test will
progress until the specified number of frames has been
transmitted on each port. The default value for nmill is 10, so the
number of frames sent will be at least 10 million.
lb_mode
Specify the loopback point for the test. By default, spinsilk uses
loopback plugs as described above. However for debug purposes
you can select other loopback modes as follows:
0: Cable Loopback.
1: Port Loopback (loopback plugs).
2: External (serdes) loopback.
3: Silkscreen loopback.
4: Serial link wrapback.
5: Internal (parallel) loopback.