Filter
Top Products
1
1-114
EMC Connectrix DS-32B2 and ED-12000B Fabric OS Reference Manual
Telnet Commands
diagfaillimit
Set diagnostics fail limit.
Syntax
diagfaillimit [limit | -show]
Availability Admin
Description Use this command to set the diagnostics fail limit to a specified value.
The fail limit is saved in nonvolatile memory and stays set until the
next execution of
diagfaillimit.
The mode becomes active as soon as this command is executed. It
does not require a reboot to take effect.
The fail limit is used to control the number of failures before certain
diagnostics test methods will abort. The normal setting is 1 so that the
tests will abort on the first failure. The exact use of this configuration
setting depends on the test method.
Operands This command has the following operands:
If no operand is specified the current value is displayed.
Example
To change the fail limit from 1 to 5:
switch:admin> diagfaillimit
Fail Limit is 1.
switch:admin> diagfaillimit 5
Fail Limit is now 5.
Config update Succeeded
switch:admin>
See Also diaghelp
limit
Specify the number of failures before
diagnostics test methods abort. The limit value
must be greater than 1. This operand is
optional.
-show
Specify this operand to display the current fail
limit setting. This operand is optional.