Filter
Top Products
1
uRouteShow
1-475
Telnet Commands
The information provided by this command should match what is
provided by
portRouteShow and topologyShow.
Operands This command has the following operands:
Hops:
Maximum number of hops required to reach the
destination domain.
Flags:
Indicates if route is dynamic (D) or static (S). A dynamic
route is discovered automatically by the FSPF path
selection protocol. A static route is assigned using the
command
uRouteConfig.
Next (Dom,
Port):
Domain and port number of the next hop. These are the
domain number and the port number of the switch to
which
Out Port is connected.
Table 1-35 uRouteShow Fields (continued)
Fields Description
slotnumber
Specify the slot number in an ED-12000B
switch. The slot number must be followed by a
slash (/) and the port number.
The ED-12000B has a total of 10 slots counted
from 1 to 10. Slot number 5 and 6 are control
processor cards, and slot 1 through 4 and 7
through 10 are switch cards. On each switch
card, there are 16 ports counted from the
bottom 0 to 15. A particular port must be
represented by both slot number (1 through 4
or 7 through 10) and port number (0 through
15).
This operand is not required for switches that
do not have blades.